Bottom Plate Replacement For Ibanez 10 And Power Series Pedals

Description

There are two major problems when applying Velcro to Ibanez 10 series pedals:

1. The Velcro won’t stick to the rubber.
2. When you try to remove it – it will take the bottom label with it, and if it’s a valuable vintage pedal, you will lose part of it’s value.

The original plate can be easily replaced by this plate – by following these steps (SEE PICTURES for reference):

1. In the kit you will get the following: 1*plate (see pic 1)
2. Remove the the metal plate by removing the 4 screws and Place the new plate carefully, and hold it in place (see pic 3)
3. Take four ((original screws)), insert them into the holes and tighten them (see pic 4)

NOTE: Screws are not included!

When you’ll decide to sell your pedal, just switch to the original plate.

This plate has a copper shielding on both sides, so it’s immune to EMI/RFI interference.

* The listing is only for the plate, the pedal in the pictures is not included!

Check out all AQUA-AUDIO plates for Ibanez, Maxon, Boss and DOD pedals

All AQUA-AUDIO products are hand made.